Hand-laid polyester-glass laminate made of rowing mats and fabrics with polyester resin

Reinforced bottom zone and bow stem

Hull in white – isophthalic, anti-osmotic gelcoat

Colored stripe on the hull + waterline

Polyester-glass laminate made using “sandwich” technology – AIREX 10 mm core

Integrated anti-slip surfaces in white

Additional reinforcements in deck hardware mounting areas

Self-draining anchor locker with cover

2 cockpit lockers

2 aft lockers – lazarette

Opening front hatch above the bow berth

Two side windows in the deckhouse, glued in, made of plexiglass

Sliding hatch made of laminate

One-piece companionway hatch made of plexiglass

2 shroud chainplates with stays integrated with hull and deck – stainless steel

Bow pulpit – stainless steel

2 side pulpits – stainless steel

Guardrail – steel wire in sheath supported by four stanchions with bases – stainless steel

2 stern pulpits – stainless steel

Tiller and rudder yoke – stainless steel, rudder blade – fiberglass laminate

2 triple turning blocks

2 triple rope clutches

2 jib track rails, 2 jib cars

2 halyard winches

2 sheet winches + bases + cleats

4 mooring cleats

Mast support at the stern with holder for lifebuoy – stainless steel

Engine bracket (pantograph) – 2 gas struts

Fixed internal ballast – weight: 500 kg

Swing keel, steel, plate type – weight: 105 kg

Interior built with HPL plywood

Double berth in the bow

Double aft berth

Saloon seat – fiberglass module

Galley

Toilet compartment with WC and sink – fiberglass module with plywood casing

Headliner

Storage compartments under the berths

Storage shelves in the bow section

Cabinet furniture instead of shelves in the saloon

Open or semi-enclosed bow partition

Stable folding table on plywood-covered centerboard casing

Berths – foam mattresses covered and finished with upholstery fabric

Hull sides lined with upholstery fabric

Electrical system – control panel, 12V socket, battery charge meter, 4 lighting points

Water system – 65L water tank, electric pump, sink in toilet, sink in galley

Gas system routed to stove (regulator/valve/stove), two-burner stove

Mainsail 17 m² – full-battened, on slides, 1 reef

Jib 13 m²

2 triple rope pockets

Mast – 9.5 m, anodized aluminum profile, with fittings

Boom – 3.5 m, anodized aluminum profile, with fittings

Standing rigging – shrouds, forestay, backstay – stainless steel, swaged ends, stainless steel turnbuckles

Running rigging – mainsail halyard, jib halyard, mainsheet, jib sheets, topping lift, boom vang, centerboard halyard, rudder blade halyard and downhaul