Hand-laid polyester-glass laminate made of rowing mats and fabrics with polyester resin

Reinforced bottom zone and stem

White-colored hull – isophthalic, anti-osmotic gelcoat

Colored stripe on the side + waterline

Polyester-glass laminate made using “sandwich” technology – AIREX 10 mm core

Integrated anti-slip surfaces in white

Additional reinforcements in areas of deck hardware installation

Self-draining anchor locker with cover

2 cockpit lockers

1 aft locker – lazarette

Opening front hatch above the bow berth

Two glued-in plexiglass side windows in the deckhouse

Sliding hatch made of laminate

One-piece companionway hatch made of plexiglass

2 shroud chainplates with stays integrated with hull and deck – stainless steel

Bow pulpit – stainless steel

2 side pulpits – stainless steel

Guardrail – steel wire with protective coating supported on four stanchions with bases – stainless steel

2 stern pulpits – stainless steel

Tiller and rudder yoke – stainless steel, rudder blade – fiberglass laminate

2 triple turning blocks

2 triple rope clutches

2 jib track rails, 2 jib cars

2 halyard winches

2 sheet winches + bases + cleats

4 mooring cleats

Mast support at stern with life buoy holder – stainless steel

Engine bracket with 2 gas struts

Fixed internal ballast – weight: 450 kg

Swing keel, steel, plate type – weight: 105 kg

Furniture made of HPL plywood

Floor – laminated teak-striped plywood

Double bow berth

Double aft berth

Saloon seat – fiberglass module

Galley

Toilet compartment with WC and sink – fiberglass module with plywood casing

Headliner

Storage compartments under berths

Storage shelves in bow section

Cabinetry instead of shelves in saloon

Open or semi-enclosed bow partition

Stable folding table mounted on plywood-clad centerboard case

Berths – foam mattresses upholstered with furniture fabric

Hull sides upholstered with fabric

Electrical system: control panel, 12V socket, battery charge meter, 4 light points

Water system – 65L water tank, electric pump, sink in toilet, sink in galley

Gas system routed to stove (regulator/valve/stove), two-burner stove

Mainsail 16.8 m² – full-battened, on slides, 1 reef

Jib 12.2 m²

2 triple rope pockets

Mast – 9.5 m, anodized aluminum profile, with fittings

Boom – 3.5 m, anodized aluminum profile, with fittings

Standing rigging – shrouds, forestay, backstay – stainless steel, swaged ends, stainless steel turnbuckles

Running rigging – mainsail halyard, jib halyard, mainsheet, jib sheets, topping lift, boom vang, centerboard halyard, rudder blade halyard and downhaul